24Ghz Digital Display FMCW Dual mmWave Barrier Gate Radar Detector with 0.5-6 Meters Detection and -40℃~+85℃ Range

1.Schematic diagram of electromagnetic wave distribution of dual-wave radar

*Width detection antenna electromagnetic distribution: detection width ≥ 1.5-2 meters.

*Height detection antenna electromagnetic distribution: detection height ≥ 1.5-2 meters.

*Electromagnetic wave crossing area.

二,Radar Technical Parameters
1,Input voltage: 12VDC
2,Rated current: 250mA
3,Operating frequency range: 24-24.25GHz4,modulation mode:FMCW
5,X-axis antenna transmit power:10-15dBm
6,X-axis horizontal beam:35±5°

7,X axis vertical beam:15±3°

8,Y-axis antenna transmit power: 10-15dBm
9,Y-axis horizontal beam: 15±3°

10,Y axis vertical beam: 35±5°

11,Detection distance: 0.5-6 meters, ±0.1 meters.

12,Working temperature: -40℃~+85℃
13,Shell size: 127*97*26mm

三,Radar Installation Specifications
1,Please choose a low-noise power adapter above 12VDC 1A for independent power supply. In the case where the gate opening signal needs to be
connected in the barrier mode, please connect the radar power supply and the gate controller power supply to the same ground (GND is connected).

2,When the gate controller is used for power supply, please ensure that the output voltage of the controller is 12V, and the output current is not less than 250mA.

3,When applied to a small car park, the optimum height from the center of the radar to the ground is 50-60cm. When it is applied to a large car park, the height can be increased appropriately.

4,The distance between the radar center and the fence pole: the octagonal fence pole is not less than 20cm, the right-angle fence is not less than 25cm.

5,The radar mounting surface should be perpendicular to the horizontal plane. And fixed and reliable.

6,The ground within the detection range should be flat without any obstacles.When the angle between the passing vehicle and the radar is greater than 30 degrees,please setup
road blocks to guide the vehicle to pass.